Geomview

[munzner]

An older version of the full source code tree is in the ftp directory
in pub/geomview/old as geomview.tar.Z. It's considerably older than
the binary version. We will release a new source version at some
point, but at the moment we're concentrating on releasing the new
version of just the binaries.

However, I strongly recommend that you first try to build your
interface as an external module to geomview, not by changing the
source of geomview itself. Geomview was specifially designed to work
with external modules, which work by sending commands to geomview
through a pipe.  The source distribution will be useful for looking at
the source for the released modules. There's a tutorial in
src/bin/example subdirectory of the source release.  For instance, see
the sweep module which allows you to generate a surface of rotation
from a line.  The warp module has a pretty sophisticated interface
that allows interactive deformation of any object, but we haven't
released the source for that yet.

Tamara Munzner          ((555) 555-5555
munzner at geom.umn.edu    The Geometry Center