[ REQ 5455]: question on geomview

[guawu at enuxsa.eas.asu.edu]

Hi, there:
	I am developing an extern module on top of geomview. One problem 
puzzles me a lot is:
	I run my modules once or twice. Fine. And then it still runs fine 
EXCEPT, I quit my module and then quit geomview, "bang", sometimes I got 
segmentation fault(core dump), sometimes I got memory fault.

	Do you know why or possible cause? Thank you very much.


	+----------------------------------------------------------+ 
	|		Guangxing George Wu			   |
        |	Department of Computer Science and Engineering	   |
	|	Office:		GWC 337    			   |
	|	Fax/modem/phone: ((555) 555-5555 (R)		   |
	|	Office phone:	 ((555) 555-5555 (O)		   |
	+----------------------------------------------------------+