[ REQ 5543]: geomview under Irix 5.2 and 5.3

[back at math.cornell.edu]

	1. Is it known if there is any difficulty running geomview
	1.50 under Irix 5.3 on an Indigo 2 ? I currently use the
	binary release under Irix 5.2.

	2. Some time ago, I tried to compile the X version on
	my Indigo 2, but ran into difficulty. It appeared to
	me this was because Makefiles were configured for Irix 4.x.
	After running into this difficulty, I didn't have time to
	go back to it and figure out what was really wrong. 
	   Should I expect to be able to readily compile the X
	version on my SGI under Irix 5.2 ? (Naturally, this is
	of interest for supporting remote display...)


						thanks,

						Allen Back