Re: Hanging up on aplications

[slevy]

> 	I've been writting a geomview aplication and wanted to
> trap some of the interupts. Apparently when an aplication is started
> from the aplications browser, and then killed by clicking on the red
> aplication name a SIGHUP signal is sent. I can sucessfull trap this
> signal and get my aplication to nicely finish and flush the output.
> Unfortunatly geomview has already stopped getting input from my
> program so its all to no avale.

You can pick up a new geomview binary by anonymous FTP to geom.umn.edu from
    slevy/geomview1.2.4.Z
It fixes both the problems you mentioned.  That is, it reads all of any file
you give it via the file browser (rather than just the first command), and it
accepts input from modules even after it's sent the SIGHUP signal.

This is just a compressed binary of geomview itself, not a tar file.
Let me know if it gives you any trouble.