OOGL-to-RIB translation

[shyu at research.att.com]

Hi!

I am a GeomView user attempting to dump a GeomView image into a RIB file
for RenderMan.  The image contains a 3D bounding box enclosing a 3D surface.
I used [RC][RR] to dump the image, and the bounding box came out very thick.
Is there a way to control the thickness (diameter of the cylinder) of the
bounding box within GeomView??

(when I used [RP][RR], the bounding box came out fine, but I still like to 
be able to control the thickness of these 12 "lines")

Thanks for your help!

Ming

 =========================================================================
  Ming-Jen Shyu (Ming)                 INTERNET:  shyu at research.att.com
  AT&T Bell Laboratories, Room 2C-263  UUCP:      att!research!shyu
  600 Mountain Avenue                  office:    ((555) 555-5555
  Murray Hill, NJ 07974-2070, USA      fax:       ((555) 555-5555
 =========================================================================