cat1 cat5

[mbp]

> I compiled geomview-src for SGI.  After I "make install" the
> program, I don't see cat1 and cat5 in my "man" directory.  Usually, if
> I get geomview-sgi-bin.tar.Z from your ftp site, I will get cat1 and
> cat5.  What do I need to do if I want to get the files in cat1 and
> cat5?

In the source distribution, the manual pages are installed into a
directory specified by the MANDIR macro in the file
$GEOMROOT/makefiles/mk.site.default.  By default this is
/usr/local/man, so if you ran "make install" without changing the
value of MANDIR, look for the cat1 and cat5 manual pages in
/usr/local/man/{cat1,cat5}.

In the binary distribution, the cat1 and cat5 manual pages come
(already formatted) in the man/cat1 and man/cat5 subdirectories.

Mark Phillips
Geometry Center