[ REQ 5447]: question on geomview

[guawu at enuxsa.eas.asu.edu]

Hi, There:
	What is GCL equivalent for the following event: select an object 
as target, and select the rotation mode, then a mouse button drag will 
make the object rotate in the direction. What is the GCL command being 
executed? And can we express "interest" on that as we did to pick? If so, 
any samples explain how to write a routine like "PICKFUNC"? 

	Is there anyway to put a simple charactore as part of the geom 
object? Say an X axis with 'X' in the end. 

	I know my question might not be an answer. Please feel free to 
even just give me a clue or hint about how to find more info or how. Any 
partial anwser is greatly appreciated too.

	Millions of thanks for all your help. 


	+----------------------------------------------------------+ 
	|		Guangxing George Wu			   |
        |	Department of Computer Science and Engineering	   |
	|	Office:		GWC 337    			   |
	|	Fax/modem/phone: ((555) 555-5555 (R)		   |
	|	Office phone:	 ((555) 555-5555 (O)		   |
	+----------------------------------------------------------+