question on using geomview

["Aggie Y. Sun" <aggies at cs.umr.edu>]

Hi,

My question is with regards to X-Geomview which I am running under Sun4.  
I have a manual for version 1.4.1, but some of the commands don't seem
to be compatible.  For instance, I would like to position my camera
window when I start up geomview and the manual suggests:
		geomview -wpos width,height[@xmin,ymin]
I type the following:
		geomview -wpos 300,300 at 100,100
and I get a 300x300 camera window but it ignores the position specified.

I also need to be able to open a new camera window which contains
no previous geometries.  I have tried this from the commands panel
using "load" and "camera" with no luck.  It seems that once there is
a geometry loaded in the camera window, all subsequent windows have
this same geometry object.  

I am also not able to control the position of the camera window.  I
have tried using the gcl command "(window Camera {position ... })" and
nothing happens.

I would appreciate some pointers.  Thanks.

Aggie Sun
aggies at cs.umr.edu