[ REQ 5144]: Compiling on RS6000 25T problems

[glenn at cim2.mm.swin.edu.au]

Hi There,
I am trying to compile your geomview package on my IBM RS6000 under
AIX 3.2.5. all goes well until the linking when the linker fails to find
0706-317 ERROR: Unresolved or undefined symbols detected:
                 Symbols in error (followed by references) are
                 dumped to the load map.
                 The -bloadmap:<filename> option will create a load map.
.XShmPutImage
.XShmDetach
.XShmAttach
.XShmCreateImage
.XShmQueryExtension
The error code from the last failed command is 8.

could you give me a pointer to the possible cause of the problem?

Cheers

Glenn Frankish

CIM Centre
Swinburne University of Technology
Melbourne Australia
glenn at cim2.mm.swin.edu.au